ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

UNAB Agent installation fails with -w switch

book

Article ID: 209376

calendar_today

Updated On:

Products

CA Privileged Access Manager (PAM)

Issue/Introduction

Client found the following .

 
1-  copy the unab-pkg-14.10.0.1494-_LINUX_X64.zip file to endpoint Linux
2- extract the unab-pkg-14.10.0.1494-_LINUX_X64.zip file
3- extract the _LINUX_X64_Ux_PKG_1410.tar.Z file
4- execute the command "./customize_uxauth_rpm -w proceed uxauth-1410.0-1494.x86_64.rpm"
 
Step 4 failed because the option "-w" is not recognized as a valid option as per the command output below.
 
[[email protected] UNAB]# ./customize_uxauth_rpm -w proceed uxauth-1410.0-1494.x86_64.rpm
Brief usage:
    customize_uxauth_rpm -h [-l lang]
    customize_uxauth_rpm -a [-d pkgdir] rpm_file
    customize_uxauth_rpm -r [-l lang] [-d pkgdir] rpm_file
    customize_uxauth_rpm -s -f file [-d pkgdir] rpm_file
    customize_uxauth_rpm -g [-f file] [-d pkgdir] rpm_file
    customize_uxauth_rpm -t tmpdir [-d pkgdir] rpm_file

 

Thanks.

 

Cause

The -w switch was discontinued  between 12.8 and 14.0 to make it easier to install without the extra step so it is no a valid switch

Environment

Release : 14.1

Component : PRIVILEGED ACCESS MANAGEMENT

Resolution

You can now install the RPM without the additional license check in customize_uxauth_rpm. You only need to use customize_uxauth_rpm if you want to preset the RPM with the environment details or customization.

Powered by Wolken Software