Would like to know to configure cdm probes with enhanced profiles.
It appears there is no option there to change loglevel and logsize from there.
What is the official suggested application to use to change debug settings or general configuration parameters for probes to avoid any conflicts ?
Release : 20.3
Component : UNIFIED INFRASTRUCTURE MGMT
The recommendation is to set up any probe in Debug mode using IM or Adminconsole in the probe settings or RAW configuration.
To open in Raw configuration, select the probe and hit CTRL + P
Using AdminConsole:
Raw configuration via Adminconsole
Go to Setup:
Then you will see the loglevel and logsize:
For General configuration for any probe using MCS/enhanced profiles is to always set up via Monitoring/OC, never via IM/AdminConsole to avoid conflits/issues.