ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Project Tiles Page Does Not Have '--All--' Option When Filtering by Active Status
Article ID: 208790
Updated On:
Products
Clarity PPM On Premise
Clarity PPM SaaS
Issue/Introduction
In the Modern UX, Project Tiles filter for "Active" is missing a selectable value for "--All--".
However, in the Project Grid, this value is present:
Cause
The Project Tiles was designed before the generic components was built and filtering was implemented different for those. Project Grid uses the generic components, but the Project Tiles does not.
Environment
This issue has been reported for Clarity 15.8.1.
Resolution
Both portlets are behaving as designed. Eventually, the Tiles page will be updated or refactored and this behavior will be revised.
In both portlets, filtering by '--All--' can be achieved by removing the attribute from the filter (filtering an attribute by '--All--' is the same as not filtering by that attribute).
Attachments
Feedback
Yes
No
Powered by
