ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Can CA-CSM to create run time datasets?


Article ID: 208615


Updated On:




Typically after an SMP/E install I make a copy of the target zone datasets as runtime datasets.  These are then used in the running of the product.  Does CSM have the functionality to perform this step?  I was thinking deployment might work but looks like deployment is for remote systems.  Can CSM create runtime datasets?


Release : 6.0

Component : CA MICS BASE SET


Yes, CSM deployment can be done for local or remote systems. It deploys to the same LPAR CSM is running one. It can use shared DASD or FTP as transmission method. 

Deployment creates copies of all the target datasets required to configure a product. After the deployment you can manually configure the product following the non CSM configuration instructions in that product documentation. There should also be instructions on how to configure it using CSM.