OPS/MVS Profile ID disappears from main OPSLOG Browse Panel with SO14824 Applied

Products

• OPS/MVS Event Management & Automation

Issue/Introduction

Interim circumvention to OPSLOG Browse Profile problem after SO14824

This document describes a manual circumvention to a problem created by SO14824. The permanent fix to the problem is PTF LU00188. After SO14824 is applied but before LU00188 is applied, use this manual circumvention to correct the problem.

While editing a profile in the OPSLOG Browse Profile main panel, scrolling to the Level 2 panel and then back to the main panel, the Profile ID field is cleared from the main panel. This behavior acts as if a change had been made to the filter criteria, even though no changes were made.

 

Environment

OPS/MVS r14.0

Cause

SO14824 

Resolution

To reload the Profile ID field, and prevent this behavior in the future, enter the SAVE primary command to re-save the profile being edited.  The Profile ID field is populated again, and scrolling to the Level 2 panel no longer clears the Profile ID field in the main panel.  

This procedure may need to be performed for each defined OPSLOG Browse profile.   After LU00188 is applied, this problem no longer occurs.