Error when creating Solaris endpoint in case the default shell of the connection account is ksh
search cancel

Error when creating Solaris endpoint in case the default shell of the connection account is ksh

book

Article ID: 208144

calendar_today

Updated On:

Products

CA Identity Governance CA Identity Manager CA Identity Portal CA Identity Suite

Issue/Introduction

This article describes the requirement for the default shell when acquiring a Solaris endpoint using the Unix v2 connector in CA Identity Manager.
 

Symptoms

  • The CA Identity Manager Unix v2 connector reports an error when creating a Solaris endpoint.
  • The connection fails even if the Solaris machine is running, reachable from the JCS machine, and the prompt regex correctly validates the OS prompt.
  • The error message reported is: "Error: [Insert specific error text here]"
 

 

Environment

  • CA Identity Manager 14.x, 15.x
  • Operating System: Solaris
  • Connection Account Shell: ksh or sh

Cause

To acquire a Solaris endpoint using the Unix v2 connector, the administrator account used for the connection must have bash as the default shell.
 

Resolution

  1. Verify the current default shell for the account used to acquire the endpoint.
  2. If the default shell is set to sh or ksh, change it to bash.
  3. Execute the following command to change the shell for the user (replace [username] with the actual account name): usermod -s /bin/bash [username]

 

Additional Information

For further configuration details, refer to the CA Identity Manager Documentation. To contact support, see Contact Broadcom Support.