ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
AlarmNotifier not showing EXTRA_ATTRS_AS_ENVVARS
Article ID: 208093
Updated On:
Products
CA Spectrum
Issue/Introduction
Attempting to configure attributes from the alarm notifier without success
I've configured the .alarmrc with the following attributes :
EXTRA_ATTRS_AS_ENVVARS=0x12bfb,0x12bfd
corresponding respectively to USER_AssetTag and USER_AssetOwner attributes that have values 'linux prod' and 'gr_linux'
But when the variables are echoed, $SANM_0x12bfb and $SANM_0x12bfd, both values are 'N/A'
Environment
Release : 20.2
Component : Spectrum Core / SpectroSERVER
Resolution
The USER_AssetTag (0x12bfb) and USER_AssetOwner (0x12bfd) attribute IDs are not available on the ProcMon2790 process model.
In order to see these attributes displayed on the AlarmNotifier, the ProcMon2790 alarm should be generated on the Device Model instead of Process Model.
Feedback
Yes
No
Powered by
