No values in Current Phase field added to a status report in the Modern UX

book

Article ID: 207571

calendar_today

Updated On:

Products

Clarity PPM On Premise Clarity PPM SaaS STARTER PACK-CLARITY PPM

Issue/Introduction

f you save the attribute from Classic and open it in Modern User Experience (UX) it shows, but if you try to change it will show no results again.

STEPS TO REPRODUCE: 

  1. Navigate to Modern UX
  2. Open any project with 1 task on it
  3. Go to Status module
  4. Add Current Phase attribute and put it anywhere on the report
  5. Observe no values available to select 

Expected Results: status Report “Current Phase” shows parent tasks from the project task list 

Actual Results: No values are available under 'Current Phase'. If you save the attribute from Classic and open it in Modern UX it shows, but if you try to change it will show no results again.

Cause

This was reviewed as DE59617 and determined to be not a bug (NAB)

Environment

Release : All Supported

Component : Clarity Project Management

Resolution

The design of the Current Phase lookup will only display "Phases". and not tasks (nor milestones). A phase is something at topmost level and has a grouping of tasks underneath.

In summary, the field will display all tasks that have a subtask on it

Powered by Wolken Software