MUX Timesheet Tabbing Is Not Working Properly

Products

• Clarity PPM On Premise
• Clarity PPM SaaS

Issue/Introduction

Modern UX (MUX) Timesheets tabbing is not working correctly / consistently. It either skips cells and/or tabs backwards if charge code or input type code are selected as the last column.

Steps to Reproduce:

1. Go to Administration > Timesheet Options > Modern UX Options  > and check 'Allow end user column configuration'
2. Navigate to MUX Timesheets
3. Create a timesheet and populate with time entries.
4. Click the Columns Flyout
5. Uncheck Charge Code and Input Type Code
6. Recheck Charge Code and Input Type Code so that they now appear as the last 2 columns in the timesheet. 
7. Select a cell and start tabbing.

Expected Results: The tabbing should be consist, left to right. When reaching the last cell in a row, it should go to next row.
Actual Results: The tabbing is inconsistent. It either skips cells and/or tabs backwards if charge code or input type code selected as the last column.

Environment

Release : 15.8, 15.8.1, 15.9, 15.9.1

Component : Clarity Timesheets

Cause

This is caused by DE59554

Resolution

This was reviewed as DE59554 and determined it will not be fixed. Please see the workaround noted below. 

Workaround:

1. Click on the column flyout
2. Uncheck all selected columns
3. Then readd the columns, selecting Input Type Code and Charge Code first so they appear as the first 2 columns. 

Additional Information

Reference Customer-Reported Defect Resolution Policy.