Easytrieve Plus (R6.4) : The IEW2651W message appeared in the the LKDLI step.

book

Article ID: 206352

calendar_today

Updated On:

Products

CA PanAudit Plus

Issue/Introduction

 
After the IMS was upgraded, the LKDLI step was reran and it finished with RC=04. And the following message appeared in the joblog.
IEW2651W 511C ESD AMODE 31 CONFLICTS WITH USER-SPECIFIED AMODE 24 FOR ENTRY POINT A000OS.       
 
Are there any impacts on their EZTPLS? How should I do?
 
 
 

Environment

Release : 6.4

Component : CA Easytrieve Plus Report Generator

Resolution

Becuase the linkage parameters 'AMODE(24),RMODE(24)' was specified as the linkage parameter in the LKDLI step, that warning message appeared. The Easytrieve Plus Report Generator supports 31bit addressing mode since R6.4, and a program module which is compiled in R6.4 has AMODE=31 attribute. (RMODE=ANY). 
Those mode parameters ('AMODE(24),RMODE(24)') should not be specified in the link step. Please remove those mode parameters from the linkage parameter in the LKDLI step.

(The EZTPA00 module should have the AMODE=31 and RMODE=ANY attributes.)