UIM 20.3 - Quick Start Guide for Creating a simple Ad Hoc report on a single metric for a group of devices to be able to set aggregation

book

Article ID: 206349

calendar_today

Updated On:

Products

DX Infrastructure Management

Issue/Introduction

This is an example of the creation of a simple Ad Hoc report that will display a single QOS metric for a group of devices for a period greater than 1 hour and that allows for a raw data aggregation.

Environment

Release : 20.3

Component : UIM - OPERATOR CONSOLE

Resolution

Select “New Custom Report”

Select “UIM Metrics Topic”

Define the time range of data that you want to display and the sources you want to display for, along with the Aggregation Type:

Select the QOS source that you will be reporting on:

To change to a line type graph, select the gears icon and select Chart type after selecting Chart from the layout type:

cabi bundled

cabi external

This then should display some data after you drag some data columns to Columns and Rows (generally the same on both versions):

Select the Columns slider and move it to Device Name under the Filters section(generally the same on both versions):

Right click on Sample Time > Change Grouping > set to desired sample points (generally the same on both versions). This is generally going to be set to 'Minute By Day' to eliminate miscalculations of given points:

Click to add Title of View (generally the same on both versions):

Right click on the gears and select to change the Chart Format (generally the same on both versions)… More information on chart formatting can be found here: https://community.jaspersoft.com/wiki/advanced-chart-formatting

Select Advanced > click Add New Property > enter Property and Value > click the check mark to save > Apply (for cabi bundled)

Select Advanced > click the pencil > enter Property and Value > click the pencil to save > Apply (for cabi external)

Turn of the option “Show measure name when only one measure is present” as desired.

Resulting report (generally the same on both versions):

Once created you can then save the view, and also create a report from the view. 

Also I can create measures of min and max of the sample values if I want to see that listed:

Once you have measures created for both min and max you can just drag and drop them onto the chart.

Attachments