Maintenance mode setting are not available for devices

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

20.3.1 Operator Console works otherwise fine but we found one issue. We can set groups into maintenance, but that option is not enabled for any device. So the icon stays gray at device level but in groups views that option is enabled and usable.

we can not set any device to maintenance mode, that option is not active, see below:

Where as in group level that option is active and enabled

Environment

UIM 20.3.1

Maintenance mode 20.30

Resolution

This problem will fixed at 20.3.3 and will go in February 2021.

 

 

Additional Information

Case Number: 32345467 & 32408456  

Defect : DE483517