S878-10 when Endevor process is running PGM=IN25UTIL with AMP=('RMODE31=ALL') on DD PROTSYM
Article ID: 203233
Updated On:
Products
Issue/Introduction
When moving from one stage to another. As part of the delete process, the Broadcom Intertest program IN25UTIL run to delete Intertest Symbols.
The program IN25UTIL fails on a S878-10 with the messages as follows:
BC1PSCRN: OPEN (F)ESTAE Routine Entered
IEF170I 4 ABBSGZZ8 BC1PSCRN: OPEN (F)ESTAE Routine Entered
IEA705I ERROR DURING GETMAIN SYS CODE = 878-10 MYBATCH NDVRBAT 00
Environment
Release : all
Component : CA Endevor Software Change Manager
Cause
This is a region size issue.
Resolution
First try increasing the region size(for example to 0M). Remember the region size coded on the STEP over rides that of the JOBCARD.
If this doesn't work try removing the AMP parm.
For example if the job was coded like this:
//MYJOB JOB TEST,'TEST',CLASS=A,
// MSGCLASS=T,PRTY=01,NOTIFY=&SYSUID
....
//NDVRBAT EXEC PGM=NDVRC1,DYNAMNBR=1500,REGION=4096K,
// PARM='C1BM3000'
....
(the processor has)
//DELSYM EXEC PGM=IN25UTIL
//STEPLIB DD DSN=&INTLIB,
// DISP=SHR
//PROTSYM DD DSN=&PROTSYM,
// DISP=SHR,AMP=('RMODE31=ALL')
//MESSAGE DD SYSOUT=&SYSOUT
//CARDS DD *
PASSWORD=12345678
DELETE=&C1ELEMENT
/*
1) Change the job card to(add REGION=0M)
//MYJOB JOB TEST,'TEST',REGION=0M,CLASS=A,
// MSGCLASS=T,PRTY=01,NOTIFY=&SYSUID
and
remove REGION=4096K, from the Endevor step as this will override the region in the job card.
2) If the above doesn't work remove AMP=('RMODE31=ALL') from the processor step in this case DELSYM.
The AMP=('RMODE31=ALL') parm puts "Control blocks and buffers above the line". This is not a require parm. This parm improves performance.
https://www.ibm.com/docs/en/zos/2.3.0?topic=ap-subparameter-definition
Feedback
