Ideal IDL5APP IDL30APB RC 12 IEW2303E VHJBSM31 on SMP/E APPLY

Products

• Ideal

Issue/Introduction

Installing Ideal and the SMP/E APPLY job IDL5APP (15.0) or IDL30APB (15.1) fails with RC=12 and message:

IEW2303E 1030 MEMBER VHJBSM31 OF THE DATA SET SPECIFIED BY CAVQLOAD COULD NOT BE FOUND

Environment

z/OS

Ideal 15.0

Ideal 15.1

Cause

Module VHJBSM31 is part of the product IPC.
IPC is a separate install and is required for Ideal as documented in sections Related z/OS Products Support for Ideal 15.0 and Related z/OS Products Support for Ideal 15.1.

Ideal 15.0 requires IPC 15.0.

Ideal 15.1 requires IPC 15.1 or 15.0

Resolution

If IPC is installed, the CAVQLOAD DDDEF in the SMP/E GLOBAL zone needs to point to the IPC CAVQLOAD library.

Run an SMP/E report with the following input to check the DDDEF definitions:

//SMPCNTL   DD *
 SET BDY(GLOBAL).  
 LIST DDDEF ALLZONES.
/*

To modify the CAVQLOAD DDDEF run SMP/E with the following input:

//SMPCNTL   DD *
 SET BDY(GLOBAL).  
 UCLIN.
 REP DDDEF(CAVQLOAD)  SHR DA(ipc.CAVQLOAD) . 
 ENDUCL.
/*

If IPC is not installed, download and install the product then modify the DDDEF as above to point to the IPC CAVQLOAD.