Missing the CCEDA and CCEMT commands after applying Sysview r16.0 PTF SO14894.

Products

• SYSVIEW Performance Management
• NXBRIDGE - SYSVIEW/ENDEVOR

Issue/Introduction

After applying SYSVIEW r16.0 PTF SO14894 the CADMIN panel is missing the CCEDA and CCEMT commands.

 

Environment

Release : 16.0

Component : SYSVIEW

Cause

The CADMIN member of Panel Library SYSVIEW.R160.CNM4BPNL does not contain the CCEDA and CCEMT commands in it.

This implies that the PTF has not been applied to your RUNTIME libraries.

Resolution

CA-SYSVIEW builds its menus dynamically.

Please review the SYSVIEW Panel library SYSVIEW.R160.CNM4BPNL(CADMIN)

Please insure that your SMP libraries point to your actual RUNTIME libraries or copy the updates from SMP into your actual RUNTIME libraries.