Error when Installing Easytrieve VSE 6.3

Products

• Easytrieve Report Generator

Issue/Introduction

When trying to run the INSJOB1 install job, for the Easytrieve VSE 6.3  product, receiving a L032I MEMBER EZTPB05.PHASE IN SUBLIBRARY. COMPLB1. PRODUCT IS MSHP CONTROLLED - CURRENT REQUEST IS IGNORED  

Job gave RC=8 in various steps.                           

Environment

Release : Easytrieve VSE 6.3

Component : CA EASYTRIEVE REPORT GEN

Cause

This problem is caused by a new MSHP controlled installation of a product in 
a library, if components remaining parts of the product, or already applied PTF's already exist in the install library for this product.                    

Resolution

PTF's were applied after the install. Remove Easytrieve, and re-install. Then run the

INSJOB1. Must get a RC=0

 

Additional Information

Another resolution is to copy the EZTPB05.phase and .object from other library into 

the Install library.