search cancel

Operator Console Timeout Settings - 20.3 and 20.4

book

Article ID: 202536

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Is it possible to modify the user session timeout settings in Operator Console?

Resolution

UIM 20.1 and earlier:

Please follow the below steps:-

== Session TimeOut configuration at the following :

Nimsoft\probes\service\wasp\webapps\root\web-inf\classes\portal-ext.properties

default values:

session.timeout=5  | session.timeout.warning=1  |   session.timeout.auto.extend=true

(This will timeout after 5 minutes and automatically request an extension after one minute as long as user is currently browsing.

== Also to the file nimsoft\probes\service\wasp\webapps\root\web-inf\web.xml

<session-config> 

  <session-timeout>30</session-timeout> 

   </session-config>

 

UIM 20.3:

This functionality is available in OC 20.3.2 - it was overlooked in 20.3 and 20.3.1 unfortunately.

UIM 20.3.2 and above:

you can look on the Operator Console robot in the following location:

Windows:  C:\Program Files (x86)\Nimsoft\probes\service\wasp\conf\
Linux:  /opt/nimsoft/probes/service/wasp/conf/

In this location you will find a file called config.properties which you can edit with the Text Editor of your choice.  Look for this section:

# Time out after five minutes, but automatically request an extension after one
# minute as long as the user is currently browsing to a portal page.  The
# timeout is really configured in ../web.xml.

session.timeout=5
session.timeout.warning=1
session.timeout.auto.extend=true


Change the timeout here, and then change the following setting in wasp.cfg on the Operator Console to match:

oc.jwt.expiryInSecs = ###

This is set in seconds and should match the setting in config.properties (which is in minutes).  In other words, if you set config.properties to 15 for a 15-minute timeout, set oc.jtw.expiryInSecs to 900.

 

Attachments