CAMM 20.2 Upgrade Question

Products

• CA Infrastructure Management
• CA Performance Management - Usage and Administration
• DX NetOps

Issue/Introduction

Installing CAMM 20.2 - when I select that I want to Upgrade (Not Typical) under the Install Set, the Pre-Upgrade Summary lists TYPICAL as the Install Set.

Should I still proceed with the upgrade even though it changes to TYPICAL? 

Environment

Release : 20.2

Component : IM Reporting / Admin / Configuration

Cause

The original base of the CAMM version.xml was prior to 3.6, and the "upgrade" install set will not be presented. It will present "typical" as above

Resolution

Make a backup of the "COMPONENTS" folder before upgrading, in case it needed to be restored

/CA/CAMM/COMPONENTS

Backup "COMPONENTS" folder

tar -zcvf COMPONENTS.tar.gz COMPOMENTS

mv COMPONETS.tar.gz /somewhereElse

then run the upgrade in /CA/software/CAMM_20.2

on LC first and then MC

Make sure this was successful by seeing if the device packs started