SAMS in our production LPAR is not starting.
See the following in the log:
******************************************************************
* --Diagnostics for CA Support Staff only-- *
* *
* Messages in these MSGExxxx output files provide additional *
* diagnostic information intended for the CA Support Staff *
* only and will be requested and interpreted only as needed. *
* Since they are not intended for the end user, they are not *
* documented, and may change at any time, without notice. *
******************************************************************
GENPARMS CALLED FOR INIT
GENCM001 CREATE Area=SSMPCB PARM CONTROL BLK Adr=0000B120 Len
GENCM001 1 common areas used, 29 free slots remaining
GENCM001 CREATE Area=PARMLOCK PARM LOCK AREA Adr=0000B3B0 Len
GENCM001 2 common areas used, 28 free slots remaining
VKG0900E: 3270UC 08 H X3270UC
VKG0900E: 3270UC 08 H X3270UC
SAM GENPARMS.I RC=0000000A
SAM INIT2 FAILED, RC=00000004
VANHCSRV .terminate: GENCM001.Find failed, Rc=8
GENFLOAD FASTCALL function is not active
GENFLOAD Current total length pre-loaded above=0
GENFLOAD Current total length pre-loaded below=0
GENFLOAD Total call count using FASTCALL= 0
GENFLOAD --- Statistics for reuse of stack ---
Vantage
The VKG0900E Message:
VKG0900E