Termination Status Report doesn't return expected result when using From and To times.

Products

• Automic Automation Intelligence

Issue/Introduction

When we run a Termination Status report with the following setting and the time window (3:30 PM – 4:30 PM), the report only returns jobs that ran between that time window on each day.

With that setting, we expect to receive all jobs that started from 9/23/20 3:30 pm to 9/24/20 4:30 pm in the jobstream (). <Note: if we set 9/23/20 3:30 pm to 9/24/20 3:30 pm, it returns 24 hours worth of data>

Since a jobstream could take more than one day to complete, we would like to be able to get all jobs in the specified jobstream for the selected period across the days consecutively.

 

 

 

 

 

Environment

Release : 6.0.1

Component : AUTOMIC AUTOMATION INTELLIGENCE ENGINE

Resolution

The behavior for the Termination Status report is working as designed, the times are used for filters within each day.


However the "Trending by Job Run History" report, does allow you to select the start and end times on specific dates that act as desired above and should provide you with similar results uncheck the "Include trending information for selected Jobs" like below: