CA Jobtrac - A job, submitted by SCL, failed with a non zero condition code , but Jobtrac status is shown as "Completed" causing the successor job to run.

Products

• Jobtrac
• Automic Automation Intelligence

Issue/Introduction

A job, submitted by SCL, ends with a non zero condition code.

Jobtrac status is shown as "Completed" causing the successor job to run.

Environment

Release : 11.0

Component : JOBTRAC

Resolution

Jobtrac is working as designed .
With no value in CCDE in the SCL it means that the RC of 0166 is considered acceptabel by Jobtrac and therefore the job is marked as COMPLETED.
Our recommendation would be to set a value in CCDE in the SCL.

Additional Information

Note the RAMAXCC parameter is only for ADD/RUN commands, not for SCLs.