ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

How to change Workload Automation DE Mail Server

book

Article ID: 200498

calendar_today

Updated On:

Products

CA Workload Automation DE DSERIES- SERVER

Issue/Introduction

We changed our mail server configuration and we need to configure the "from.email.address" parameter in the following server file:

\conf\sharedpropscache.properties

But we get the message as below that the file should not be modified:

#GENERATED BY THE SERVER FOR ITS INTERNAL USE - WILL BE OVERWRITTEN - DO NOT MODIFY!

How I change this parameter?

 

Environment

Release : 12.2

Component : AUTOMATION ENGINE

Resolution

You can consult the following documentation page for detailed information:

https://techdocs.broadcom.com/us/en/ca-enterprise-software/intelligent-automation/ca-workload-automation-de/12-2/configure-the-email-settings.html

Configure the Email Settings

You can specify the following email addresses for server communications:


* An email address to identify email sent by a particular server

Follow these steps:

Connect to the server as an administrator using CA WA Desktop Client.

Open the Admin perspective.

Right-click Topology in the Admin view, and select Open from the pop-up menu.

The Topology view opens.

Right-click the server connection in the Topology view, and select Configure Shared Parameters from the pop-up menu.

The Server Shared Parameters view opens.

Select the Email tab, and modify the following fields as appropriate:

Email address to identify CA WA Server

Specifies an email address that identifies the server that you receive messages from.

Click Save at the top right corner of the Topology view.

The changes are saved.

Restart the server for the new value to take effect. In a CA WA High Availability configuration, restart the Primary server.

The new value takes effect.