ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Interfaces are being discovered without their model names in Spectrum 10.4.1
Article ID: 200468
Updated On:
Products
CA Spectrum
Issue/Introduction
Occasionally you may notice interface models do not contain a model name and just the index number (ex. _10) after being discovered. If you perform a device reconfiguration the model names then get discovered properly.
Environment
Release : 10.4.1
Component : Spectrum Discovery & Modeling
Resolution
This is a known Spectrum issue and engineering has created the Spectrum_10.04.01.PTF_10.4.127 patch to resolve this issue.
Please contact Spectrum support for a copy of the patch and installation instructions.
Feedback
Yes
No
Powered by
