ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Anomaly Detector Does Not Connect To NFA Console

book

Article ID: 200155

calendar_today

Updated On:

Products

CA Network Flow Analysis (NetQos / NFA)

Issue/Introduction

Unable to add the Anomaly Detector to NFA console.

Environment

Release : 10.0

Component : NQRPTA - REPORTERANALYZER

Resolution

In this scenario the not all prerequisites were installed.  Uninstall AD verify the prereqs are meet.  Reinstall AD, now try to add AD to the NFA console. 

Additional Information

The Anomaly Detector prereqs are the same for NFA:

Configure Data Execution Prevention (DEP)
Install .NET Framework
Install IIS, ASP, COM+, and SNMP
Configure SNMP on Windows Servers
Disable IPv6 Connections on Windows Servers
Firewall Configuration
Web Browser Support
Configure Regional Settings

Full pre-req details for NFA/AD r10.0 details are available here: 

https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/network-flow-analysis/10-0-0/installing/system-recommendations-and-requirements/windows-servers.html

 

Powered by Wolken Software