Defined a new ACF2 role and a role group but when running the ACFRTPRX report these permissions
are not being reported.
Release : 16.0
Component : CA ACF2 for z/OS
When running the ACFRPTXR report to report on X(ROL) records after changes to X(ROL) records,
the 'F ACF2,NEWXREF,TYPE(ROL)' command needs to explicitly state TYPE(ROL) since the
default if no TYPE is specified is X(SGP).
Scenario:
The following command was entered to activate the new X-ROL records:
F ACF2,NEWXREF
ACF79302 SOURCE XREF TABLE RE-BUILT
The above defaults to source groups if TYPE is not specified.
The following command was entered to activate the new X-ROL records which resolved the concern:
F ACF2,NEWXREF,TYPE(ROL)
ACF79302 ROLE XREF TABLE RE-BUILT
Per the ACF2 documentation SGP is the default when F ACF2,NEWXREF is issued without a TYPE specification:
F ACF2,NEWXREF[,TYPE(SGP)]
SGP specifies the SGP table cross-references logical and physical source names to the source groups that contain them. SGP is the default.