S0C1 while running CATRMFU 12.6

Products

• TLMS Tape Management

Issue/Introduction

When we run CATRMFU on Z/os 2.4 we receive S0C1, runs fine on z/OS 2.2. 

Environment

Release : 12.6/14.0

Component : CA TLMS Tape Management

Cause

PSW AT ENTRY TO ABEND   078D1000  00E7C7F0  ILC  02  INTC  0001
0PSW MODULE     ADDRESS = 00000000_00E7C7E8  OFFSET = 00000008
 NAME=IDAIIPM3

 

Resolution

PSW AT ENTRY TO ABEND   078D1000  00E7C7F0  ILC  02  INTC  0001
0PSW MODULE     ADDRESS = 00000000_00E7C7E8  OFFSET = 00000008
 NAME=IDAIIPM3

*

 IBM APAR OA58976 should correct the problem.

https://www.ibm.com/support/pages/apar/OA58976

*

Text of the IBM PTF:

***************************************************************** 
USERS AFFECTED:                                              
** All VSAM users of ISAM interface to use BISAM macros at z/OS 
** 2.4				                                                      ****************************************************************** 
PROBLEM DESCRIPTION:                                         
** ABEND0C1 because of a bad address for READ and WRITE macros  
** in DCB.                                                      ****************************************************************** 
RECOMMENDATION:                                              
** Apply PTF.                                                   *****************************************************************
A change in compiler level changed the offset of the entrypoints for READ and WRITE causing an ABEND0C1 due to a badbranch.