DESIRED STATE Being Reset to UP by OPSMAIN
search cancel

DESIRED STATE Being Reset to UP by OPSMAIN

book

Article ID: 198833

calendar_today

Updated On:

Products

OPS/MVS Event Management & Automation

Issue/Introduction

After setting the desired state of a task to DOWN, it is automatically reset to UP. The following messages appear in the OPSLOG                                                                                                                       
OPS7914T SSM AUDIT: STCTBL.TASK1 UPDATED by OPSOSF xxxx.xxx DESIRED_STATE=DOWN     
                                           
OPS7914T SSM AUDIT: STCTBL.TASK1 UPDATED by OPSMAIN STATEMAN DESIRED_STATE=UP          

SSM is in active mode and TASK1 is also in ACTIVE mode. Message T=PASSIVE appears in the "Message" column of the panel 4.11.2:

Environment

Release : 13.5

Component : OPS/MVS

Resolution

Table was in PASSIVE mode in the OPSVIEW panel 4.11.1:

Overwriting the "P" with an "A" solved this problem

Attachments