ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

DX APM 20.2 GA Install and Internal Artifactory

book

Article ID: 198640

calendar_today

Updated On:

Products

DX Operational Intelligence

Issue/Introduction

Tried installing DX APM 20.2. However, the installer did NOT ask for any authentication credentials. 

Supposed to ask for credentials AFTER the Registry Location was entered. 

Command line to login to the artifactory works fine after prompting username/password.

But DX APM 20.2 installer just failed with no permission, without asking username/password

Cause

The version of artifactory  returns a different “needs credentials” message than Broadcom artifactory. 

Broadcom has version Enterprise Plus 7.6.3 rev, and that was what we tested and validated against.  the current one has version 6.20.1. 

Environment

Release : 20.2

Component : CA DOI AO PLATFORM COMPONENTS

Resolution

The issue is addressed and will be added to the next release 20.2.1.

 OR

Upgrade to artifactory 7.6.3, 

Powered by Wolken Software