ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
IEFTMS50 1XX- 08 HSM, HSM, RESIN1, 9520,700038,00001,.HMIGTAPE.DATASET,TMC=.HMIGTAPE.DATASET
Article ID: 19775
Updated On:
Products
CA 1 Tape Management
CA 1 Tape Management - Copycat Utility
CA 1 Tape Management - Add-On Options
Issue/Introduction
When an HSM.HMIGTAPE tape is copied using TAPEREPL OVOL(vvvvvv) command, the DSN created will be HSM.COPY.HMIGTAPE
Once this new tapeis read in as input if the EDMID is not the same as the original DSN then it will cause:
Once this new tapeis read in as input if the EDMID is not the same as the original DSN then it will cause:
IEFTMS50 1XX- 08 HSM ,HSM ,RESIN1
,9520,700038,00001,.HMIGTAPE.DATASET,TMC=.HMIGTAPE.DATASET
IEFTMS50 ***** CA 1 ABEND,F1,08 *****
Environment
Release: ONE...00200-12.6-One-TAPE MANAGEMENT
Component:
Component:
Resolution
Verify the new DSN=HSM.COPY.HMIGTAPE created by the TAPEREPLOVOL(vvvvvv) command has the same EDMID as the HSM.HMIGTAPE in the TMOEDMxx member to prevent the IEFTMS50 1XX-08 abend when reading the tape in as input.
Additional Information
Note:
You should NOT assign a different EDMID to the COPY versus the primary. Change the EDM options so that your EDMID on the tape for example, "HSM3", matches what is in your TMOEDM00 member which would be HSM1 for example.Feedback
Yes
No
Powered by
