How to configure mail settings for ReportScheduler in UMP Cluster

Article Id: 197230

Status: Published

Updated On: 13-08-2020 03:37

Products:

DX Infrastructure Management , NIMSOFT PROBES , DX Infrastructure Management

Issue/Introduction:

We have 5 UMP servers in a cluster setup.
When we configure mail settings in ReportScheduler on all UMP server separately, a report will be mailed several times (one by each UMP server). If we configure mail settings on one single UMP server only, we won't receive an email at all.

Environment:

Release : 9.2.0

Component : UIM - UMP_REPORTSCHEDULER

Resolution:

Following are the configuration properties that an administrator should add to the /webapps/reportscheduler section of "wasp.cfg":

• execute_email_actions – Enter a value of “false” on UMP servers that should not execute or email reports.

You would need to set this on all 4 secondary nodes so that the primary node only sends email.