Received OPS0049E after maintenance applied
Article ID: 197051
Updated On:
Products
Issue/Introduction
On the first IPL following the application of the most current maintenance the following message was produced:
OPSOSF OPS0049E INCOMPATIBLE VERSION OF JES2 OFFSET TABLE FOUND, APPLY OPJ2DF MAINTENANCE.
This message was produced 4 times. the following message was then produced:
OPS0046I Attempting to match a default JES2 offset table
OPS0047I JES2 OPJ2DF offset table found for JES2 release z/OS 2.4
OPS0050O JES2 INITIALIZATION DETECTED
Can you tell me why the OPS0049E errors occurred?
Environment
OPS/MVS
Cause
In the documented cases, these causes for this message were identified:
- Timing Issue
- Absence of required product maintenance
- Need to reload OPJ2DF from OPSVIEW 4.1.5 panel
Resolution
Review each of the solutions below and implement the one that best fits your scenario. If none of these solutions work, proceed with opening a support ticket and reference this document as part of the troubleshooting process.
Timing Issue
An attempt to access the JES2 offset table was made prior to JES2 Initialization completing successfully. Once JES2 initialization completes, the message should cease.
Absence of Required Product Maintenance
If the messages persist after JES2 initialization, it's advised to review the list of related JES2-related maintenance to ensure it's been applied to the environment receiving the errors. To review the list of published maintenance, access the OPS/MVS Product Page, click "Solutions", then search for "JES2" in the box noted with "Search with solution name, component, etc."
Need to Reload OPJ2DF via OPSVIEW 4.1.5 Panel
The Module Display shows vital information about OPS/MVS modules. This is particularly important for getting information on the release and service pack of the product currently running.
To reload the module, place an "R" on the line next to OPJ2DF and press "Enter".
Additional Information
Feedback
