Problem preparing the H2 database for Web Viewer 14.0
Article ID: 196878
Updated On: 09-27-2021
Products
Output Management Web Viewer
Issue/Introduction
I'm trying to install and configure Web Viewer 14.0 per the documentation in the Tech Docs portal and in 'Prepare an H2 Database' under 'Prepare the Application Database' section under 'Configure' it states in step 3:
"Run the DDL using the H2 Console, or you can use the H2 RunScript Tool.
The database is created."
For this test installation I plan on using an internal H2 database. Where do I find the H2 RunScript Tool? I can find no mention of it in either the CVDEOPTN or CVDEJCL View product data sets.
For this test installation I plan on using an internal H2 database. Where do I find the H2 RunScript Tool? I can find no mention of it in either the CVDEOPTN or CVDEJCL View product data sets.
Environment
Release : 14.0
Component : CA Output Management Web Viewer
Resolution
When using an embedded or internal database the database is automatically created when starting up the Tomcat server.
Feedback
Was this article helpful?
Yes
No
Powered by
