Some Attributes Get Blanked After Publishing a Status Report in the New UX

Article Id: 196035
Status: Published
Updated On: 28-07-2020 06:20
Products:
Clarity PPM On Premise , Clarity PPM SaaS
Issue/Introduction:

After publishing a draft status report, some custom attributes with value (tested with Large String, Lookup attributes) get blanked for the subsequent drafts. The published status report has the correct/expected value.

Steps to Reproduce

  1. Create a new attribute of type Large String or Lookup in the Status Report object, with an API Attribute ID.
  2. Open a project.
  3. Navigate to 'Status' tab.
  4. In the 'Current' status report, add the attribute.
  5. Change the value for the attribute.
  6. Publish the report

Expected Results: The published report has the value from step 5, and after navigating to 'Current', the new draft status report still has that value for the attribute.

Actual Results: The published report has the value from step 5, and after navigating to 'Current', the new draft status report has the attribute without any value.

Environment:

This issue has been observed in Clarity 15.6.1.

Resolution:

The issue cannot be reproduced in Clarity 15.8.1.

Please upgrade to the latest Generally Available version of Clarity.