CA SYSVIEW - Change CTHRESH parameters via batch process or TSO

Products

• SYSVIEW Performance Management
• NXBRIDGE - SYSVIEW/ENDEVOR

Issue/Introduction

Is there a simple way to change or add CTHRESH entries via batch process or TSO command?

.

Environment

Release : 16.0

Component : SYSVIEW

Resolution

Using the THRESH command for MVS thresholds or the CTHRESH command  for CICS thresholds modifications can be made dynamically.

The changes exist only for the life of the STC.

Permanent changes must be made in the MVSTHRSH & CTHRESH parmlib members themselves.

Additional Information

Also you can export the definitions to a PDS member (so you can get a record of your dynamic changes)
... example CTHRESH EXPORT