ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Spectrumgtw stops synchronizing the alarms between UIM to Spectrum
Article ID: 195865
Updated On:
Products
CA Spectrum
Issue/Introduction
The bidirectional alarm synchronization stops on the spectrumgtw probe. The problem showed up after installed the OI connector.
Environment
Release : 10.4.2
Component : Spectrum Integrations
Resolution
Applied the Spectrum_10.04.02.D50 debug patch.
Contact the Broadcom support to request the patch.
Feedback
Yes
No
Powered by
