UIM - Is it possible for the CDM probe to dynamically monitor new mount points/disks without needing a probe restart?
book
Article ID: 194968
calendar_today
Updated On:
Products
NIMSOFT PROBES
DX Infrastructure Management
Show More
Show Less
Issue/Introduction
The CDM probe enables monitoring of newly added mount points/disks following a probe restart.
Is it possible to have it enable the monitoring dynamically as soon as it sees the mount point/disk i.e. without the need to restart the probe ?
Environment
Release : 9.2.0
Component : UIM - CDM WITH IOSTAT
Resolution
Currently this is not possible however there is a Feature Request open with Development requesting this:
F102107 CDM support for Auto Monitoring of New mount-points/Disks to the server on the fly.
Feedback
thumb_up
Yes
thumb_down
No