CA Datacom DB01801E - INTERFACE ERROR - 44 on different LPAR

book

Article ID: 193989

calendar_today

Updated On:

Products

CA-11 CA Datacom - AD CA Datacom/DB CA Datacom/AD CA Datacom

Issue/Introduction

Trying to access CA Datacom from a different LPAR gets error message:

DB01801E - INTERFACE ERROR - 44

 

Cause

Error 44 indicates the Program Call (PC) routine has not been installed in the local LPAR.

The PC routine must be installed on all LPARs that will be accessing CA Datacom.

This problem can also be caused by installing the PC routine with PARM PC=TEST

PC=TEST should rarely be used and only for testing new maintenance.

The PC=TEST routine will not be used unless the DBSIDPR module is also assembled with the PC=TEST parameter.

 

 

Environment

Release : 14.0, 15.0, 15.1

Component : CA Datacom

Resolution

The normal mode of operation is to specify in the PARM PC=PROD.

Run CAIRIM to install the PC routine with PC=PROD. Input parameters  for 15.x are:

PRODUCT(CA DATACOM) VERSION(BD15) INIT(DBCR5PR)                   -
LOADLIB(CAI.THLQ.CABDLOAD)                                        - 
PARM(PC=PROD,PCC=DBPCCPR)

See INSTJCL member BDRIM01 (for DB) or AXRIM01 (for AD).

 

Additional Information

See documentation section Establishing Communication with z/OS and article 48599