How to reset COUNT field for a CA Sysview threshold
search cancel

How to reset COUNT field for a CA Sysview threshold

book

Article ID: 193294

calendar_today

Updated On:

Products

SYSVIEW Performance Management NXBRIDGE - SYSVIEW/ENDEVOR

Issue/Introduction

Is there a way to reset COUNT field for a threshold definition (for example in CTHRESH display)?

Environment

Release : 16.0

Component : SYSVIEW

Resolution

The RESET line command on CTHRESH  will reset the count field for the specific threshold. To reset the count for every definition, a block line command could be used. 
Moreover, a  User command could be created. The logic could be wrapped into a user command and just run the user command. There is currently not way to reset the count field for only a specific region unless a specific threshold for the region has been created and only used the reset line command on this definition.

Additional Information

see CTHRESH help panel