Ethernet interfaces on Palo Alto firewalls are reporting an incorrect value of interface speed

Article Id: 192312

Status: Published

Updated On: 04-06-2020 17:12

Products:

CA Infrastructure Management , CA Performance Management - Usage and Administration , DX NetOps

Issue/Introduction:

Ethernet interface speeds on palo alto firewalls are reporting incorrect speed. Note that this is different than the speed issues reported for HSCI interfaces (a separate ticket was closed for this issue previously). CAPM should be reading ifHighSpeed OID

1.3.6.1.2.1.31.1.1.1.15

However, CAPM is reading ifSpeed.

Environment:

Release : 3.7

Component : IM Reporting / Admin / Configuration

Resolution:

In this case the Ethernet's had a ifHighSpeed 1.3.6.1.2.1.2.2.1.15 of 0 so CAPM defaulted to using ifSpeed 1.3.6.1.2.1.2.2.1.5 for the speed of the interface this is working as designed.