z/OSMF classic (or tree-style) interface - Register your SMP/E Environment (CSI)
search cancel

z/OSMF classic (or tree-style) interface - Register your SMP/E Environment (CSI)

book

Article ID: 192058

calendar_today

Updated On:

Products

Mainframe Software Manager (Chorus Software Manager) CHORUS SOFTWARE MANAGER

Issue/Introduction


Go to start of metadata

Using z/OSMF classic (or tree-style) interface.

Steps to register a software instance using the z/OSMF classic (or tree-style) interface.

Environment

Release : 6.0

Component : Chorus Software Manager

Resolution


Go to start of metadata
 

Select Software > Software Management in the left-hand menu and then click on Software Instances link in the Software Management tab.



A table with existing Software Instances appears. To add new Software Instance, click on Actions button and select Add… from the drop-down menu.



Then follow the wizard to register new Software Instance which represents your CSI. You would need to provide following information:

  • Name: The name of your new Software Instance. You will identify your SMP/E Environment by this name in z/OSMF.
  • System: The system where your CSI resides. It should be only CA31 in this case.
  • Global Zone CSI: The data set name of your CSI. It must end with “.CSI”.
  • Target zones: Select all target zones which are present in your CSI.

After the wizard is finished successfully, you should see your new Software Instance in the table of all Software Instances.

 
 

Additional Information

Attachments