ACF2 ACFAE194 error during CICS startup after CICS region upgrade
search cancel

ACF2 ACFAE194 error during CICS startup after CICS region upgrade

book

Article ID: 192000

calendar_today

Updated On:

Products

ACF2 ACF2 - z/OS ACF2 - MISC

Issue/Introduction

ACF2 and ENF PTFs for CICS toleration for CTS 5.5 were applied, although an earlier release of CICS was running.

These messages were seen at CICS startup: 

 ACF04056 ACCESS TO RESOURCE CHCK TYPE Rxxx BY logonid NOT AUTHORIZED
 ACF04056 ACCESS TO RESOURCE CMPE TYPE Rxxx BY logonid NOT AUTHORIZED
 ACFAE194 Category 1 transaction validation failed                   
 ACFAE098 CICS ACFAE194 Reply 'RETRY', 'GO', or 'CANCEL'    

Why are these messages issued when CTS 5.2 or 5.3 is being run?

Environment

Release : 16.0

Component : CA ACF2 for z/OS

Cause

ACF2 CICS initialization processing validates access by the region LOGONID for all the CICS Category 1 transaction codes. From the IBM CICS doc, the CMPE and CHCK transactions are standard in CICS TS 5.4 and 5.5, and therefore the ACF2 CICS 5.5 fixes have to support and validate these. 

Resolution

Messages ACFAE194 and  ACFAE098 and ACF04056 seen above are resolved using the ACF2 message doc for ACFAE194:

'Review the ACF04056 messages preceding this one to determine what category 1 transactions the region is prevented from issuing. Then compile resource rules to allow the region to issue those transactions or add them to the SAFELIST. Until this is done, the CICS region is not able to issue the category 1 transaction(s). This message is accompanied by message ACFAE098. Reply CANCEL to the ACFAE098 message - results are unpredictable for a reply of GO or RETRY.'