After applying all PTFs, started a CICS regions using the Library with those PTFs. When testing a blockmode application, get the following error:
CEE3501S The module TIRHSTGC was not found.
From compile unit TIRHSTG at entry point TIRHSTG at entry offset +000002AC at address 306A194.
The old nor the new CEHBPLD1 load library had this module.
Release : 8.5
Gen Run Time, Distributed
Gen Run Time, Block mode
Apply the HOLDDATA from PTF RO68649.
The PTF contains two HOLDDATA.
One was to DEFINE PROGRAM TIRHSTGC to CICS Once the definition to CICS was set, the problem was resolved.++HOLD (RO68649) SYSTEM FMID(CEHC850)
REASON (ACTION ) DATE (14121)
COMMENT (
+-----------------------------
| CA GEN COMMON CICS MODULES Release 8.5 |
+----------+------------------
|SEQUENCE | After Apply |
+----------+------------------
|SEQUENCE | Before using GEN RUNTIMES IN CICS |
+----------+------------------
|PURPOSE | DEFINE NEW RUNTIME DLL TIRHSTGC AS A PROGRAM |
| | |
+----------+------------------
|USERS | ALL CICS USERS |
|AFFECTED | |
+----------+------------------
|KNOWLEDGE | CICS ADMINISTRATOR |
|REQUIRED | |
+----------+------------------
|ACCESS | ACCESS TO CICS CSD |
|REQUIRED | |
+----------+------------------
**************************
* STEPS TO PERFORM *
**************************
DEFINE PROGRAM TIRHSTGC TO CICS IN CICS RESOURCE DEFINITION OR
GET DEFINITION FROM DEFCICS JOB INCLUDED IN PTF.
).
There is no equivalent Gen 8.6 PTF because TIRHSTGC was in the 8.6 GA version when it was first released in 2016 (Install Gen Runtime Load Library Modules)