CA7SIDSH error ABEND=S222

Products

• CA 7 Workload Automation

Issue/Introduction

I see the following messages when shutting down CA7SIDAH:

19.50.37 STC73963  CAL2M172E Monitor(CA73) received unexpected term from thread(EventListener)
19.50.59 STC73963  CAL2M171I Monitor(CA73) is stopping                         
19.56.56 STC73963  BPXP018I THREAD 2794680000000000, IN PROCESS 458983, ENDED  722  
   722             WITHOUT BEING UNDUBBED WITH COMPLETION CODE 40222000        
   722             , AND REASON CODE 00000000.                                 
19.56.57 STC73963  IEF450I CA7SIDSH CA7SIDSH - ABEND=S222 U0000 REASON=00000000  723
   723                     TIME=19.56.57                                       
19.56.57 STC73963  $HASP395 CA7SIDSH ENDED - ABEND=S222                        

Environment

Release : 11.3

Component : CA WORKLOAD AUTOMATION iDASH FOR CA 7

Resolution

It could be that Automation is reacting to early in canceling the task. The S222 is the result of your system operators (or an authorized TSO/E user) issuing a CANCEL command against the Dispatch started task. 

Sx22  -   Job has been cancelled.  The value of x will vary depending on the way the job was cancelled.
              S222 means job was cancelled by a user or operator without a dump. If a TSO session times
               out you will probably get an S522 abend code.

              S222  -   The job was cancelled (by subsystem or operator) because it violated 
              some restriction