ESP544W meassge question

Products

• ESP Workload Automation

Issue/Introduction

Setting up an APPL using templates and received the following error message.
/*DEL                                                   
==>ESP544W JOB XXXXXXXX DELETED, WILL NEED RESUBMISSION 
The action on the message manual is to correct action...but since this is a simulation Warning...my question is is their any action need to be taken. As i don't really see an ERROR.

Environment

Release : 12.0

Component : CA ESP WORKLOAD AUTOMATION

Cause

The ESP544w message reads as follows.

544W
JOB xxxx DELETED, WILL NEED RESUBMISSION
Reason:
An error, described by a preceding message, was found in the JCL of a job being submitted or scanned.
System Action:
If a job was being submitted as result of an Event execution, it will be deleted and require resubmission.
Action:
Correct the error and resubmit the job if necessary.

Resolution

Look for an error prior to the ESP544w message.  This will need to be corrected first and then it will correct the ESP. An example would be error below.

ESP2582E MEMBER 'XXXXXXXX' NOT FOUND IN DATA SET XXXX.XXX.XXX
         WARNING: NO JOB CARD FOUND FOR JOB XXXXXXXX