Brand new install of ACF2 fails with error message ACF8A014 and a disabled wait state.
book
Article ID: 190450
calendar_today
Updated On:
Products
ACF2ACF2 - z/OSACF2 - MISC
Issue/Introduction
Installing a new z/OS and ACF2 on a new LPAR. First IPL fails. Syslog shows:
$HASP373 ACF2 STARTED IEF403I ACF2 - STARTED - TIME=13.09.14 ACF8A014 ACF2 IS NOT DEFINED AS A SUBSYSTEM
and the system goes into a disabled wait state. The disabled wait program status word (PSW) is 0003000000000000000000000000acf2.
CAXILPA is in the LPA list at IPL, and CAX1LINK is in LNKLST and APF authorized. What is the problem?
Environment
Release : 16.0
Component : CA ACF2 for z/OS
Resolution
Message ACF8A014 points to the ACF2 LPA library being in error. Either the LPA libraries were not setup properly in the PARMLIB member, or the aliases not being included in a copy of the library. Make sure the LPALSTxx member of SYS1.PARMLIB has the correct ACF2 library, and the commas on every line after the library till the last line which does not have a comma. The library should have an alias for several modules, like this:
Name Prompt Alias-of Size TTR AC AM RM DDBPSWD2 00000940 00132C 00 31 ANY DDBPSWD3 00001380 001135 00 31 ANY ICHSCDMY SAFRTSEC 00003488 00140E 01 31 ANY ICHSEC00 SAFRTSEC 00003488 00140E 01 31 ANY ICHSEC05 SAFRTSEC 00003488 00140E 01 31 ANY SAFRTSEC 00003488 00140E 01 31 ANY **End**
There are other modules that have aliases that change over time. Compare the copied library to the install TARGET library in SMPE.
Additional Information
IBM has more information on LPALSTxx setup on their website.