MQ Agent Metric Clamp
Article ID: 190153
Updated On:
Products
CA Application Performance Management Agent (APM / Wily / Introscope)
CA Application Performance Management (APM / Wily / Introscope)
INTROSCOPE
DX Application Performance Management
Issue/Introduction
An MQ Application is using 300+ queues but in APM, only able to see only 200+ queues due to Agent Metric clamp.
To resolve the metric clamp issue on the Agent side, we increased the value of introscope.agent.metricClamp from 5K to 200K.
The problem still persists.
To resolve the metric clamp issue on the Agent side, we increased the value of introscope.agent.metricClamp from 5K to 200K.
The problem still persists.
Environment
Release : 10.7
Component : APM Agents, MQ Monitor Agent
Cause
The MQ Agent does not use the Agent Profile for configuring metric clamps.
Normally the MQMonitor uses more than 50000 metrics approximately 53K
Normally the MQMonitor uses more than 50000 metrics approximately 53K
Resolution
The MQMonitor does not recognize the introscope.agent.metricClamp in the Agent profile. Instead, change the EM Metric Clamps in XML configuration file apm-events-thresholds-config.xml file.
Feedback
Yes
No
Powered by
