How to add back the Security event log in Status tab

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

We used to see the Security Event log in the Status tab in a previous release of ntevl probe (4.20), but in 4.22 onward we no longer see it.

Environment

Release : 9.0.2

Component : NTEVL

Cause

Removed default monitoring of security logs on fresh probe installation. There is no impact on the existing security log monitoring during upgrade from previous versions.

Resolution

You can add it back by following the steps below:



Click on Apply and OK to save and restart the probe.

Launch the probe configuration again, you will see the Security Event Log.

Additional Information

https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/ca-unified-infrastructure-management-probes/GA/alphabetical-probe-articles/ntevl-nt-event-log-monitoring/ntevl-nt-event-log-monitoring-release-notes.html

4.22

What's New:   Added support in probe Infrastructure Manager (IM) to specify maximum queue size for larger events to restrict huge memory consumption.   For more information, see  Configure Probe Properties  in ntevl IM Configuration.   Removed default monitoring of security logs on fresh probe installation. There is no impact on the existing security log monitoring during upgrade from previous versions.   Fixed Defect:   The probe version 4.21 caused high memory and CPU utilization.  Support case numbers 00292089 , 00291482,  00289006,  00280297,  00245245,  00165265.

GA

February 2016