search cancel

Clarity : JasperSoft Report data getting stacked from previous run

book

Article ID: 189303

calendar_today

Updated On:

Products

Clarity PPM SaaS Clarity PPM On Premise

Issue/Introduction

We observed that when user runs same report multiple times, the data is getting stacked along with previous run but when user goes out of the Advanced Reporting area and then run, it does not do that.

Steps :-

1. Login to Clarity
2. Navigate to Advanced Reporting.
3. Open Project KPI's report.
4. Populate Project.
5. Select Projct XYZ and run the report.
6. After the result, filter for another project ZXY and select that.
7. Run the report again.

Expected Results :- Report runs for the second selected project ZXY.
Actual Results :- Report runs for both XYZ and ZXY.

Cause

Jasper Server Input Controls retain the previous value. If you filter another record in the input control it gets added to the previous value and the report runs for both previous and new input control values.

Environment

Release : 15.5.1

Component : CA PPM SAAS APPLICATION

Resolution

Jasper Input controls retain the previous selection under Selected Tab.

We need to clear those values from Selected Tab or select Click on None to clear them.