BAS00413E >>>>> THE SAME LOGICAL SYSID HAS BEEN DEFINED FOR MULTIPLE ORIGINAL SYSIDS

Products

• MICS Resource Management

Issue/Introduction

Receiving a BAS00413E in the BASPGEN job when there are multiple lpars defined for logical sysid. 

BAS00413E >>>>> THE SAME LOGICAL SYSID HAS BEEN DEFINED FOR MULTIPLE ORIGINAL SYSIDS.
BAS00413E >>>>> IF IT IS POSSIBLE FOR DATA FROM BOTH OF THE ORIGINAL SYSIDS TO ENTER CA MICS
BAS00413E >>>>> FOR THE SAME TIME PERIOD, THE VALIDITY OF SOME FILES WILL BE DESTROYED.
BAS00413E >>>>> IF YOU ARE SURE THAT THIS CAN NEVER HAPPEN, CONTACT TECHNICAL SUPPORT FOR FURTHER INSTRUCTIONS.

BAS00414E >>>>> ERROR(S) ENCOUNTERED IN SYSID PARM DEFINITIONS.
BAS00414E >>>>> $SYSID AND $SYSIDN SAS FORMAT GENERATION ABORTED.
BAS00414E >>>>> CORRECT ERROR(S) AND EXECUTE AGAIN
                               
  ex.
  prefix.PARMS(SYSID)
     
       |* SYSTEM IDENTIFICATION DEFINITIONS      */                        
                                                                           
       B19B CS1   '3090'    XA     765.9 14.64  'CS1 '                      
       D19D CS1   '3090'    XA     765.9 14.64  'CS1 '                      
       E19E CS1   '3090'    XA     765.9 14.64  'CS1 '                      
       V29V CS2   '3090'    XA     765.9 14.64  'CS2 '                     
       W29W CS2   '3090'    XA     765.9 14.64  'CS2 '                  
        X29X CS2   '3090'    XA     765.9 14.64  'CS2 '                     

       

Environment

Release : 14.2

Component : CA MICS

Cause

You cannot assign two concurrently used SYSIDs to the same logical SYSID.
If a logical SYSID is specified more than once, the CA MICS generation process flags the condition as an error.  

Resolution

To allow multiple SMF SYSIDs to be assigned to the same logical SYSID, you can override this with SYSPARM=DUPSOK on the BASPGEN EXEC statement.
ex. 
//BASPGEN EXEC MICSDM,SYSPARM=DUPSOK,

Additional Information

Click here for more information about Computing System Parameters (SYSID)