HOLD instructions for WEBUI PTFs after a base install of CA Dynamic Capacity Intelligence (DCI) 2.0
search cancel

HOLD instructions for WEBUI PTFs after a base install of CA Dynamic Capacity Intelligence (DCI) 2.0

book

Article ID: 188752

calendar_today

Updated On:

Products

Dynamic Capacity Intelligence

Issue/Introduction

CA Dynamic Capacity Intelligence 2.0 has been just installed. Then the WEBUI PTFs are applied. Are the HOLD instructions for these PTFs:
+----------------------------------------------------------------------+
|     CA Dynamic Capacity Intelligence                Version 2.0      |
+----------+-----------------------------------------------------------+
|SEQUENCE  | After Apply                                               |
+----------+-----------------------------------------------------------+
|PURPOSE   | Apply changes to the DCI Web UI                           |
+----------+-----------------------------------------------------------+
|USERS     | All DCI Web UI Users                                      |
|AFFECTED  |                                                           |
+----------+-----------------------------------------------------------+
|KNOWLEDGE | Mainframe and USS skills                                  |
|REQUIRED  |                                                           |
+----------+-----------------------------------------------------------+
|ACCESS    | CA DCI SMPE product libraries and USS directories         |
|REQUIRED  |                                                           |
+----------+-----------------------------------------------------------+
                      **************************
                      * STEPS    TO    PERFORM *                     
                      **************************                     
After SMP/E work is complete, rerun customization job $05USS (located
on the CFHRSAMP library) with the replaced HTTPINST/HTTPINSTB element
locateded on the CFHRDATA library to apply the updated GUI elements. 
please see the CA DCI 2.0 installation guide for more information.   
still required in this case?

Environment

Release : 2.0

Component : CA DYNAMIC CAPACITY INTELLIGENCE

Resolution

There are two possible answers:
 
1) the SMP/E installation of the base product has been completed, all the PTFs are then applied, finally the installation jobs ($05USS among them) are executed: the HOLD instructions can be disregarded.

2) the SMP/E installation of the base product has been completed, then the installation jobs ($05USS among them) are executed and finally all the PTFs are applied: in this case, the $05USS job must be re-executed, so the updated WEBUI elements are copied on the USS directory of DCI.